Skip to content
Serving Fremont and nearby cities Mon–Fri: 8 AM–8 PM · Requests accepted 24/7 · (213) 723-6751

Heating Repair in Livermore, CA

Serving Livermore and nearby cities. Tell us about the job and we’ll call you back to confirm the details.

Tell us what’s going on

Prefer to talk? (213) 723-6751

The short answer

SureBreeze AC Repair Service repairs gas furnaces and heat pumps in Livermore homes, from ignition failures and cold air to short-cycling and thermostat problems. We explain what we find before any work starts and give you a straight answer on repair versus replacement. Bay Area Air District rules don't require you to replace a working furnace, so repairing a sound system is still a valid choice.

When the furnace or heat pump quits on a cold Livermore night, you want a clear diagnosis and a fix that holds up. SureBreeze AC Repair Service repairs gas furnaces, heat pumps, and the ductwork and controls that go with them in homes across Livermore, about 13 miles northeast of our base in Fremont. We tell you what failed, what it takes to fix it, and whether repair still makes sense for your system, so you can decide without pressure.

Heating problems we see in Livermore homes

Livermore sits inland in the Tri-Valley, away from the Bay's moderating influence, so winter nights here often feel colder than they do closer to the water. Many heating systems sit unused through a long, hot summer and then run hard once the weather turns. That pattern tends to expose worn parts in the first cold weeks of the season.

Common calls include:

  • Furnace won't ignite, or lights and then shuts off after a few seconds
  • Blower runs but the air from the vents is cool
  • Heat pump short-cycles, ices over, or seems stuck in defrost
  • Thermostat isn't calling for heat or reads the wrong temperature
  • A burning smell that doesn't fade after the first few cycles of the season
  • Rooms far from the unit stay cold while others are fine
  • Banging, squealing, or rattling when the system starts or runs

How a heating repair visit works

We start with the simple things that cause a surprising number of no-heat calls: thermostat settings and batteries, power to the unit, the gas supply, and the air filter. From there we test the furnace's startup sequence step by step, including the igniter, flame sensor, pressure and limit switches, inducer and blower motors, and any error codes on the control board.

For heat pumps, we check the outdoor unit, defrost controls, reversing valve, capacitors, and refrigerant-side performance. On gas furnaces we also look at the heat exchanger and venting, because a crack or blocked flue is a safety issue, not just a comfort problem.

Before we repair anything, we explain what we found in plain terms and what the fix involves. Many common repairs, such as a dirty flame sensor, a failed igniter, or a weak capacitor, can often be handled in one visit when the part is on the truck. Less common parts may need to be ordered.

Gas furnace safety comes first

If you smell gas, leave the house right away and call your gas utility or 911 from outside. Don't flip switches or try to relight the furnace. Once the utility has cleared the home, we can diagnose and repair the furnace.

If a carbon monoxide alarm sounds, get everyone outside and call for help. Also avoid repeatedly resetting a furnace that keeps locking out. The lockout is often the system protecting itself, and forcing it to run can make the problem worse.

Repair or replace? What current Bay Area rules mean

Under Bay Area Air District Rule 9-4, natural gas furnaces manufactured from 2029 must meet a zero-NOx emission standard. In practice, that points homeowners toward heat pumps when a furnace is replaced after that date. The rules do not require you to replace working equipment. They only come into play when an existing furnace fails or is replaced, so repairing a furnace that's in good shape is a reasonable choice.

If your furnace is older and the repairs keep adding up, it can be worth thinking ahead about a heat pump on your own schedule rather than during an emergency. Note that the federal Energy Efficient Home Improvement Credit (25C) only covered qualifying heat pumps placed in service before December 31, 2025, so it isn't available for new installations. Bay Area homeowners can check BayREN and their local clean energy provider for current heat pump incentives. Amounts and availability change by funding cycle, so we confirm the current offer before quoting it.

Before you call, and where else we work

A few quick checks can save you a visit: confirm the thermostat is set to Heat and has fresh batteries, check the breaker for the furnace or air handler, make sure the furnace's front panel is fully seated so its safety switch is closed, and replace a clogged filter. If the heat still won't come on, give us a call.

Along with Livermore, we repair heating systems in Pleasanton, Dublin, and San Ramon, as well as Union City and Milpitas closer to our Fremont base.

More services in Livermore

Related

What to expect

How a visit goes

  1. Diagnosis comes first

    We test and inspect the system to find the actual cause before suggesting parts or replacement, so you aren't paying to guess.

  2. Options you can compare

    When a system could be repaired or replaced, we lay out both paths, what each involves and the tradeoffs, so you can decide with the full picture.

  3. Straight answers on rules and incentives

    We explain how local air district rules and current rebate programs apply to your home, and we confirm current incentive details before quoting them.

FAQ

Common questions

Why does my furnace start and then shut off right away?

A common cause is a dirty flame sensor that can't confirm the burner has lit, so the furnace shuts off the gas as a precaution. A failing pressure switch, blocked venting, or overheating from a clogged filter can cause similar symptoms. We test each one to find the actual cause.

Is it normal to smell burning when I first turn on the heat?

A light dusty smell for the first few cycles is usually dust burning off the heat exchanger after the summer. If it lingers, smells electrical, or smells like gas, turn the system off. For a gas smell, leave the house and call your gas utility.

Do I have to replace my gas furnace because of the new Air District rules?

No. The Bay Area Air District rules don't require replacing working equipment. They apply only when a furnace fails or is replaced. The zero-NOx standard covers gas furnaces manufactured from 2029.

Why is my heat pump blowing cool air in winter?

It may be in a normal defrost cycle, which can briefly feel cool. If it lasts a long time, the problem could be a stuck reversing valve, a defrost control fault, low refrigerant, or a thermostat setting. We check each of these during the visit.

Can I still get a federal tax credit for a new heat pump?

No. The federal 25C credit covered qualifying heat pumps placed in service before December 31, 2025, and isn't available for new installations. Check BayREN and your local clean energy provider for current incentives. We confirm the current offer before quoting it.

Do you also serve areas near Livermore?

Yes. Along with Livermore, we serve Pleasanton, Dublin, San Ramon, Union City, and Milpitas.

Need heating or cooling help in Fremont?

Tell us what your system is doing and we'll schedule a visit to diagnose it. You'll get a clear explanation of the problem and your options before any work begins.

Call (213) 723-6751 Request Service